Newbie questions

[Nch93]

Hi guys. I have sysnand 7.0.1 and emunand 6.2.
I also have nand back up 7.0.0( before downgrade to 6.2) and nand back up 6.2( made it after creat emunand 6.2) . I have some questions as listing below

1. Which emunand should i keep for back up? 6.2 or 7.0.0? Should i make sysnand back up too? If i want to recover sysnand, how to do it? Or just restore by SX boot screen.
2. If i delete auto RCM, i have to use JIG every time i want to turn on? Is it harm if i turn on and install Auto RCM ( ban, brick,etc..)

Thank you for reading guys! Sorry for my bad English!

 

[imprezgc8]

Hi guys. I have sysnand 7.0.1 and emunand 6.2.
I also have nand back up 7.0.0( before downgrade to 6.2) and nand back up 6.2( made it after creat emunand 6.2) . I have some questions as listing below

1. Which emunand should i keep for back up? 6.2 or 7.0.0? Should i make sysnand back up too? If i want to recover sysnand, how to do it? Or just restore by SX boot screen.
2. If i delete auto RCM, i have to use JIG every time i want to turn on? Is it harm if i turn on and install Auto RCM ( ban, brick,etc..)

Thank you for reading guys! Sorry for my bad English!

1. 7.0 emunand will not currently boot since 7.0+ is not supported yet. You can keep both though. You can restore you nand through the SX bootloader, but make sure that you have a 7.0 nand backup as well.

2. Yes, if you do not sure autoRCM you will need to use the jig every time you shut down the console.