Nintendo Working, The SX was working and now can't boot

[gogoalpha]

Hello,

The system was working fine but out of the blue it does not anymore.

The Switch is ok, I can switch it on normally when the jig is not in.

But when I try to boot to the SX PRO, then the switch won't start. When I but it off it does start.


Note: The jig (?) when plug to a pc is still showing a green light...
I have tried formatting a micro sd again...

 

[gogoalpha]

Download a new copy of the boot.dat file from sx.xecuter.com
Format your SD card again
put ONLY boot.dat on the root of the sd card
Boot your switch to RCM mode and try sending the payload from PC with tegra RCM smash.

report back with your findings.

Well I think I am stuck with the same issue but it looks like it is clearer:

The switch does'nt go to RCM mode.
I can't use the program you refer to...

 

[optantic]

Well I think I am stuck with the same issue but it looks like it is clearer:

The switch does'nt go to RCM mode.
I can't use the program you refer to...

hold Power for 15 seconds, insert Jig to right joycon slot, insert Dongle to usb c slot, hold Vol+ and push Power 1 time and continue to hold Vol+ and see if you will get the TX Boot Menu

 

[gogoalpha]

I tried your method.

turn off the switch
Insert JIG
Insert dongle to usb
Push and keep volume +
Push once power.

The nintendo doesn't start at all.

For the dongle, no lights when starting.
When plugged to a power, light is on. no blink straight light.

 

[gogoalpha]

Actually it worked then, but just once. Not since

 

[optantic]

Actually it worked then, but just once. Not since

hold Power for 15 seconds
charge the dongle on a computer for 10-15 seconds using the usb cable
then try it boot again

 

[gogoalpha]

​SOOOOOOO

I managed to be able to use the tegra RCM smash. I loaded the payload with that.

It is working now. For the moment.
Just in case for those passing by:

1 - download tegra RCM smash (google is your friend)
2 - go to Xecuter team and download the x loader
3 - put it in the RCM and do the normal procedure as described above.

Problem on my side is that the job is done by the tegra RCM smash but seems like the dongle doesn't work...

I am not able to do that with the dongle ...

An advice ?

 

[optantic]

​SOOOOOOO

I managed to be able to use the tegra RCM smash. I loaded the payload with that.

It is working now. For the moment.
Just in case for those passing by:

1 - download tegra RCM smash (google is your friend)
2 - go to Xecuter team and download the x loader
3 - put it in the RCM and do the normal procedure as described above.

Problem on my side is that the job is done by the tegra RCM smash but seems like the dongle doesn't work...

I am not able to do that with the dongle ...

An advice ?

plug in dongle to Switch then power on normally, just by pushing Power and see if you get a solid green light on the Home Menu,

 

[gogoalpha]

plug in dongle to Switch then power on normally, just by pushing Power and see if you get a solid green light on the Home Menu,

hello !

Yes I have a solid green light.

But the issue seems to be that when I use a different way than the computer the charge is not supported so it doesn't work...