No boot with RGH demon enabled .xsvf file

J

jannusz

Junior Member
Dec 16, 2011
15
0
Romania
Hi,
I have a Corona V3.
Install CR3Lite with timing file 3-2 boot time is under 30sec.

I install demon. It's my first demon install. I dont have a QSB so i solder wires between demon and MB points.
Stock Nand is on XBOX flash and RGH nand is on demon.

When i try to boot RGH with timing file 3-2 (without demon enabled) it is booting under 30sec, but when i change to boot from stock, then CR3 is glitching and after some time RED light is coming up on front-panel. I read many post and it is normal, when not demon enabled xsvf file is programed to CR3Lite.
When i put the demon enabled 3-2 timeing file, then stock nand boot's up instanty (without glitching), but demon nand with RGH is glitching endlessly.

What is wrong ? What can I try ?
My Demon and CR3Lite install images :DSCF7887.JPGDSCF7893.JPG
 
J

jannusz

Junior Member
Dec 16, 2011
15
0
Romania
On the photos attached, the ribbon cable si not yet cnonected. While debugging all cables are connected. When i try with normal .xsvf file (whitout Demon enabled checkbox) then the demon nand and coolrunner works fine, but the onboard nand does not work (Coolrunner try to glitch and it should not try and after 10-20 seconds i get in red front light). When i send the Demon enable xsvf file to the coolrunner then the onboard nand boots up, coolrunner does not glitch. But when i change to boot from demon nand then coolrunner is glitching endlesly. Is timeing difference between 3-2 Corona without demon and 3-2 Corona timeing file with demon support ? I try every timeing file with demon support and no one boots up. Sorry for my bad english.
 
J

jannusz

Junior Member
Dec 16, 2011
15
0
Romania
I have not try to boot retail nand from DemoN. I try to boot retail nand only from MB Nand. DemoN is with RGH nand.
 
You must log in or register to reply here.