RGH NO green light on CR and Xell boot with falcon

[redonep4]

I try make rgh on my falcon Mb all was fine till I connect that MB to tv and discovered is no green light on coolrunner and no boot to xell. Im use that tutorial http://team-xecuter.com/forums/showthread.php?t=75945&highlight=phat+rgh.

If anyone have any idea what can be wrong please share with me. Later on I'll add some SS Thx

 

[Anobix]

I would double check your soldering. Can you post pictures of the board with the solder points?

 

[diaboliq20]

I would say it's the wiring too - make sure no wires are close to anything that causes interference (coils or the red +3.3v wire) - check your soldering, and then try building the ecc with multibuilder

 

[redonep4]

Ok guys I'll do like im said when come back from work any way thx for fast reply

 

[seanr28]

falcons work flawlessly, will deffo be soldering or programming

 

[redonep4]

Here is some of pict. how I connect all wires

 

[DanTechMods]

Hard to tell from the pic but your yellow wire may be touching 2 of the points.

 

[redonep4]

Maybe is touch it but that wires is no naked and I don't thing this is problem with it

 

[DanTechMods]

I would still angle it to make sure it is not touching at all. These little things can make all the difference in micro electronics.

 

[redonep4]

Right now I improve my soldering in this point and CR start blinking green light but still can't boot xell

 

[redonep4]

update: When i try dump nand and check in 360 dump tool its said can't load file.Please any one help me as im pulling out my hear right now