Ive put it in program and normal mode but no green light. This is probably a noob error by me but is this normal.
COOLRUNNER No green light.
- Thread starter brent1wer
- Start date
john mathews
VIP Member
http://team-xecuter.com/forums/showthread.php?t=96474post picture of your coolrunner and install fillout template
Last edited:
ultimate360
VIP Member
You clearly have a different issue going on, I have installed over 150 CRs without a single issue with the chips. Check out my thread that I opened about having this issue from a while back when I was RGH noob, it should help you. :
http://team-xecuter.com/forums/showthread.php?t=144652
http://team-xecuter.com/forums/showthread.php?t=144652
Last edited:
Thanks for the help. But I replaced c14 on the board and when i try to program it i get solid red light and it cant find the coolrunner.
Beaver_Buffcoat
BANNED
I saw your other thread about C14. You need to replace the capacitor with a voltage value that is equal to or higher than the capacitor that was there in the first place. You may have also bridged the pads where C14 resides (underneath the cap).
Might have to look for a replacement Coolrunner or wait for CR4.
ETA: The capacitance value (rated in Farads) must be EQUAL to the original part. You can get away with slightly higher or lower capacitance values to test, but it is not recommended.
Last edited:
I replaced it with a 10uf 16v exactly what its rated at and i double checked the pads but thanks for the help. When the cr4 comes out ill get one when will it?
Beaver_Buffcoat
BANNED
I don't know when the CR4 will be available, but it can't be that much longer.
Maybe you killed the cap with too much heat? I dunno. Have you tried taking readings (off & while powering on) with a multimeter? What kind of voltage are you getting before and after the cap in question?
Beaver_Buffcoat
BANNED