No Picture?!?!?!?!

[ReMix]

Re: Lite-On 9xxx drive not powering up!

obviously you didn't read the jungleflasher tutorial

you must solder a couple things to your PCB board cuts in order to be able to extract your key

cutting traces is to isolate the flash chip so you can perform a full dump of it after soldering a couple components to the PCB

 

[oc]

Re: Lite-On 9xxx drive not powering up!

I have a lite-on 9xxx series and ck3 probe v2 dual pogo... I'm also using this tutorial since it's a new probe, http://team-xecuter.com/ck3-probe-ii-mra-jungle-flasher/ What I don't understand is when you make the trace cuts the drive has no power, so what does this mean? Do you have to solder a jumper wire another trace to get power to retrieve the key? Thanks

 

[ReMix]

Re: Lite-On 9xxx drive not powering up!

no, the probe supplies the power for flashing