ANSWERED No Power?

[mikey63366]

Got jasper 16mb, had problems with it freezing and went to move the wires around behind the board. Now the Xbox will not turn back on. Coolrunner has red light..

Below are some pictures.. Not sure what happen..

 

[Krafter]

Explain what you mean by it wont turn back on. Do you get the green light on the console?

 

[x360ccm]

post pics of the stby clk.

also i would never place wires like you did.

 

[mikey63366]

No green light on the console. Console will not power back on...

 

[Krafter]

You have done something to the STBY_CLK point. Take pictures of it as suggested above.

 

[fanni]

Have you tried removing wires to see if console will power on

 

[mikey63366]

post pics of the stby clk.

also i would never place wires like you did.

Ya i know, it's mess right now.. trying to get the power back to xbox..


I'm using the alt stby clk..

---------- Post added at 18:56 ---------- Previous post was at 18:54 ----------

You have done something to the STBY_CLK point. Take pictures of it as suggested above.

I'm using the alt one.. i think this pic right here

http://imageshack.us/photo/my-images/43/20120114182214.jpg/

Have you tried removing wires to see if console will power on

Yes tried remove the green wire and the stby_clk

 

[Krafter]

Why are you using the alt? Did you damage the top connection? The system wont boot if the trace from the HANA is broken.

 

[mikey63366]

Why are you using the alt? Did you damage the top connection? The system wont boot if the trace from the HANA is broken.

No i did not damage it, the alt point is little easier

 

[Krafter]

Do you have a multimeter? If so then measure the resistance of R4B24 coming from the HANA. It should be 33 ohms. I suspect it's blown but maybe not.

 

[mikey63366]

Do you have a multimeter? If so then measure the resistance of R4B24 coming from the HANA. It should be 33 ohms. I suspect it's blown but maybe not.

no multimeter, looks like I may need to pick one up and then return it,,

 

[x360ccm]

stby clk issue i think.

no power but i bet the cool runner has a red light on it.

 

[mikey63366]

Well the xbox starting powering up again? I was moving the green wire around and I was able to power on the xbox. Now I need to figure out why it's freezing at the xbox logo on startup. Looks like I got short somewhere or bad solder point somewhere.. This xbox driving me crazy,,,

 

[BL4K3Y]

Are your wires routed away from the coils underneath the board?

 

[mikey63366]

Are your wires routed away from the coils underneath the board?

Yep they are going to get some new pics up in few...

 

[mikey63366]

Finally got it working again! Not sure what was wrong with the green causing it not to power up. Freezing problem had to do the orange wire use the main point and fixed the freezing at start up. werid!