LITEON DG-16D4S - SLIM no spi status

XL3THAL VIP3RX

XL3THAL VIP3RX

VIP Member
Nov 23, 2010
588
48
sheffield,pontefract,wakefield uk
www.aspire-sheffield.co.uk
ive flashed my uncles slim a couple months ago and evrything went sweet.
ive come to update it today,i removed the solder to use sputnik probe,intro drive and it showed the spi status.
ive probed the hole and it didnt make the bleep noise,
so i outro drive and intro again but now it dosnt show the spi status.

ive reset the pc sevral times and it still dosnt show my spi status...

is there any way of sorting this?? cheers in advance.
 
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
xbox360 hacker

xbox360 hacker

BANNED
Feb 28, 2011
1,405
0
united kingdom
Not my guide just a google copy and paste job



Step 1: Turn the dial on the digital multimeter to the continuity test setting. The universal symbol for this setting is a circuit with sound waves. This signifies that when the meter detects a complete circuit, a sound will be emitted from the multimeter.

Step 2: Plug the red probe into the red voltage, Ohm, diode jack. Plug the black probe into the com jack in the multimeter.

Step 3: Disconnect the power source from the circuit including the wall plug and any batteries.

Step 4: Test circuit boards or circuit wiring by holding one lead to one end of a trace or wire and the other lead to the other side of the lead or wire.

Step 5: Listen for a beep or tone from the digital multimeter. When the sound is emitted by the multimeter, then the circuit is continuous. If no sound is emitted by the digital multimeter then there is a problem with continuity of the circuit.

Edit: Posted same time as martin. Sorry martin
 
Last edited:
D

DUSTYB3N

VIP Member
Jun 17, 2011
462
0
Blackpool UK
Let me google that for you... :(


Sent from my iPhone 4S using Keyboard
 
You must log in or register to reply here.