I have been reading for hours and finally have resorted to posting.
My problem is this, I have installed an xecuter 2.6 chip, then on its bootup I installed bios X2.4983.06 using Flashbios with a DVD-R. Both bars fully progressed and it turned itself off. Now all it does is continue to go to the flashbios screen instead of the "xecuter rox my box" splash screen.
I have tired 2.6 auto installer and creating an xiso of V1.8_3753 using Qwix with no luck. The drive is spinning up but it does nothing because it always ends up at the: Load bios from HDD;Load bios from CD; Lock;Unlock screen.
Any ideas? Thanks in advance
btw its a V1.0
My problem is this, I have installed an xecuter 2.6 chip, then on its bootup I installed bios X2.4983.06 using Flashbios with a DVD-R. Both bars fully progressed and it turned itself off. Now all it does is continue to go to the flashbios screen instead of the "xecuter rox my box" splash screen.
I have tired 2.6 auto installer and creating an xiso of V1.8_3753 using Qwix with no luck. The drive is spinning up but it does nothing because it always ends up at the: Load bios from HDD;Load bios from CD; Lock;Unlock screen.
Any ideas? Thanks in advance
btw its a V1.0
