RGH No splash screen

[Shuttleu]

Hi, i have glitched my Trinity console and it usually boots after 4-7 cycles and worked as expected
however i now no longer get a splash screen

so i press the button, the greenlight on the coolrunner will flash until it glitches the console, then after 10 seconds i will be shown the dashboard on the screen.

its not a major issue, but it makes it seem as if it is taking longer to glitch than it actually is

any help on getting the splash screen back is greatly appreciated

~shut

 

[nofeloniesyet]

Hi, i have glitched my Trinity console and it usually boots after 4-7 cycles and worked as expected
however i now no longer get a splash screen

so i press the button, the greenlight on the coolrunner will flash until it glitches the console, then after 10 seconds i will be shown the dashboard on the screen.

its not a major issue, but it makes it seem as if it is taking longer to glitch than it actually is

any help on getting the splash screen back is greatly appreciated

~shut

do you have a hard drive plugged up to it? if so try removing it all together and see what happens.

 

[Shuttleu]

i unplugged both the external and internal hdd's and it still didn't show any splash screen

 

[Martin C]

What dashboard were you on before you started?

 

[Shuttleu]

well i hadn't played on it for a while so im assuming it was 13599 or 13604

---------- Post added at 18:03 ---------- Previous post was at 18:02 ----------

is there any way to tell from the original nand dump i have?

 

[socalbill]

So you have no signal during the swirling ball, and Xbox 360 screens, the first screen you see is the Metro UI dash? Did you try other cables, tv/monitors? I bet this is unique to the setup you gave right now, and if you change something, you will see the screens. Try it before f'ing up your console.

 

[Shuttleu]

looking at jtag tool it was on 13146

---------- Post added at 18:21 ---------- Previous post was at 18:20 ----------

i tried multiple screens and i have tried both HDMI and A/V

 

[nofeloniesyet]

him and i sorted this issue earlier,post answered.

 

[marcusinteruptus]

Do you want explain how too save others that might gt this?

 

[Martin C]

him and i sorted this issue earlier,post answered.

Can you reply with what you did?

 

[nofeloniesyet]

well he had told me that nandpro and xell,which he used to flash this image to xbox,stated he had a bad block at 0x51. he sent me a nand of his and i loaded in 360 flash tool and seen no bad blocks,so at this point he told me that xell was auto remapping this bad block for him i told him to try an image in flash360,flash non remapped image to the box using that,and he was all good,seems xell was remapping a block that didnt need it? i also have a jasper here i have no audio on dash i tried this on and it worked also.hope this helps someone else out

martin you seen anything like this yet? or have an explanation of this for me? cause i still do not get it.ive seen boxes that nandpro had no bad blocks at all and xell remap some anyway,like the jasper of mine i stated above.but this guy that started this thread did say he had bad block in nandpro and xell.so thats whats throwing me off here.

 

[Shuttleu]

sorry for not replying

as nofeloniesyet said, i used flash360 and it all seems to be working perfectly now

i even fiddled about with the blue wire and managed to get the box booted in about 1-2 tries every time