Hi all,
I recently installed an Xecuter DemoN with CoolRunner Rev C. Everything appears to work OK, I had a successful NAND dump, and I used that image to flash the CoolRunner and create and write an ECC image to the Xbox NAND (I haven't done anything to the demon nand yet). When I turn the xbox on, it boots up but does not have any audio or video output (tried both AV and HDMI). I then reflashed the nand with the original nand dump, I could tell that it booted successfully because I could use the controller, open and close the DVD drive, etc... but still no video or audio. Before performing the install, I had to push down on the AV/HDMI port when I initially opened the xbox and then HDMI worked until I finally did the install. When I reflashed the nand to stock, I did manage to get component to work once by pulling up on the connector and down on the port, but I have not been able to get it to work since. I don't know whether this is an AV/HDMI port problem, or if I did something with the demon or coolrunner to make the port not work. Before the install, HDMI and Component worked fine after pushing down on the port that one time.
Any help would be much appreciated!
I recently installed an Xecuter DemoN with CoolRunner Rev C. Everything appears to work OK, I had a successful NAND dump, and I used that image to flash the CoolRunner and create and write an ECC image to the Xbox NAND (I haven't done anything to the demon nand yet). When I turn the xbox on, it boots up but does not have any audio or video output (tried both AV and HDMI). I then reflashed the nand with the original nand dump, I could tell that it booted successfully because I could use the controller, open and close the DVD drive, etc... but still no video or audio. Before performing the install, I had to push down on the AV/HDMI port when I initially opened the xbox and then HDMI worked until I finally did the install. When I reflashed the nand to stock, I did manage to get component to work once by pulling up on the connector and down on the port, but I have not been able to get it to work since. I don't know whether this is an AV/HDMI port problem, or if I did something with the demon or coolrunner to make the port not work. Before the install, HDMI and Component worked fine after pushing down on the port that one time.
Any help would be much appreciated!