Hello, I installed the 2.6CE in a v1.0 xbox, and I am faced with a problem; the xbox reboots twice and then FRAGs at me when I boot the TSOP. More concerningly, when I switch on the chip, both banks (still default bioses) fail to give any video output while everything else performs normally.
Additionally, I was curious because on my chip, all the wire sockets (on the bottom edges) seem as if they would be much better placed if I was to rotate the chip 180 degrees. (it's currently turned out, so that the board is hanging out on the same side of the LPC bus as the IDE channel) Simply overlooked in the design stage?
Additionally, I was curious because on my chip, all the wire sockets (on the bottom edges) seem as if they would be much better placed if I was to rotate the chip 180 degrees. (it's currently turned out, so that the board is hanging out on the same side of the LPC bus as the IDE channel) Simply overlooked in the design stage?