non-xenon kit #5

[1moment]

After much searching I have found 1 install picture on the forums for these qsbs, I would like a bit more information on it before purchasing. I know it gets soldered to the bottom of the board and uses the alt db1f1 point on the bottom of the board just above FT2R2 however the other point used looks like it goes to R2P12 where im used to using the aud_clamp spot on Q2N1. Are these the same? or what SMC setting would I use when building the image for using the resistor point? is this as stable as aud_clamp? Obviously the on/off switch will engage/disengage the jtag im assuming, what does the jumper/other switch do? Basically is it the same as this http://img340.imageshack.us/img340/5687/newwiring.jpg I don't see any transistors (er 2n3904's) anywhere.

Thanks

 

[1moment]

bump...

 

[relax2010]

You can compare with this very perfect tutorial here.

http://team-xecuter.com/forums/showthread.php?t=55189

As M AzeeM K described in the above tutorial,this method will less problem that may
happen due to DB1F1 connection.
But for non-xenon Jtag kit#5,you need to install it bottom of the board instead of all
the process shown in the picture you link to. It's the alternative choice.