Not a frag issue ... no lights at all issue?!?

[Hamboner]

Ok... Here is my problem... I ordered 5 x2.6 modchips ...Installed all five chips ok on various xbox's from version 1.0 - 1.5. However I have one chip that refuses to cooperate. When connected either pin header style or wire installed it will not light up at all ...both the external switch and the chip itself remains off. I can then take that chip out and use one of the other x2.6 chips to test with and they work fine. Is it possible that perhaps this might possibly be a bad chip? Not to say that I have ever had one ... done probably about 150+ modchips by now and have never seen an xecuter chip ever act this way. Just curious if there is any way to try and test further. I have various different version xbox's on hand and many other chips to test with but just dont know what to do next now.I'll quickly recap ... when this chip is installed on a version 1.0 xbox (wire install or pinheader) Tried both ways.... the x2.6 remains unlit both on the chip and the switch... when I exchange JUST the chip...not the switch or any other wires ...it works fine.
Any help would be greatly appreciated.

BTW: Xecuter rulezz the xbox modchips world! =)

 

[Fantmx]

Sounds like a bad chip. Contact your supplier and get it exchanged.

 

[Hamboner]

Thx for the reply. I am extremely surprised to actually get a bad chip by Team Xecuter. This is the first ever which is why I would like to point out that I am not the least bit upset about it. These modchips are very solid and I dont think there is any other xbox chip supplier that can deliver the quality that Team Xecuter does.
Neways. Thx for the info.