Not able to read NAND with Matrix Nand Flaher (light on)

Rander

Noob Account
Jun 24, 2019
6
1
Sheol
Hello. I have a problem with the NAND reading.

1. I use JRunner 8 with xeBuild 1.19.

2. My NAND reader is Matrix Nand Flasher.

3. I have installed the drivers from this topic.

4. The power supply is connected (orange light on, the console is not turn on).

5. I post the pictures of wires below.

6. When I connect the power supply the red light of the reader is on - but when I connect the USB cable it shines more intensive (dunno if it has any meaning).

7. I have tested two USB cables.

8. The error message:

Version: 01
Flash Config: 0x00000000
Can not Continue
Notes:
As you can see, I had to scrap some plate on point 1 to get to the path on which I could solder wire.













Help, any suggestion?
 

Rander

Noob Account
Jun 24, 2019
6
1
Sheol
Solved. The wires were connected correctly. I used the multimeter and the problem lied in the first point on the chip, I added some more solder and it connected properly. I also recommend for future readers checking if the wires do not touch each other on the other side of the Xbox board. Still, thanks for the help.