RGH Now Jasper 512 is RRod

lucifer

lucifer

VIP Member
Aug 2, 2011
171
0
Techmology
www.techmology.net
well last night i did the RGH a Jasper 512. The booting time was too slow so I soldered the 0.068uF GND and Point A. after that I have found that the coolrunner was rev B. So the problem is

with Glitch nand -> coolrunner not Glitch and no display
with stock nand -> Its showing RRod.

Note: I have checked coolrunner with mine console its working.
 
2

2615863

VIP Member
Nov 30, 2011
552
33
Tampa,FL
lucifer said:
well last night i did the RGH a Jasper 512. The booting time was too slow so I soldered the 0.068uF GND and Point A. after that I have found that the coolrunner was rev B. So the problem is

with Glitch nand -> coolrunner not Glitch and no display
with stock nand -> Its showing RRod.

Note: I have checked coolrunner with mine console its working.
Click to expand...

Whats the secondary error code on the rrod? I had this happen to me, I was RGH a falcon, booting xell, I even had fans on it but it rrod . Now its another rrod Phat..
 
W

WNYConsoles

Troll Eating Dogs
May 21, 2010
2,195
128
Blackwater, Great Plains
team-xecuter.com
I think the PLL could be cleaned up a bit, doesn't look that solid and I see some whiskers which could cause a short. Remember to use flux, the solder will melt into place nicely.

May want to move PLL to the default wiring position as well and not run under the GPU.
 
x360ccm

x360ccm

BANNED
Jan 18, 2011
3,616
0
south coast UK
secondary error code has been ask for.

with stock nand Its showing rrod is that with the coolrunner still solder to the xbox.or have you removed the coolrunner.

your solderin looks bit naff on the green wire going to the pll bypass point.

and what the stuff all around the point you not had glue over it and then removed it have you.
 
Last edited:
Martin C

Martin C

VIP Member
Jan 10, 2004
35,981
0
Scotland, UK
www.team-xecuter.com
If it was flashing before you started to mess with capacitors, then you've soldered something wrong and have probably blown CPU_PLL_BYPASS now. Check R7R17 (Above CPU_PLL_BYPASS) and see what value you get.
 
lucifer

lucifer

VIP Member
Aug 2, 2011
171
0
Techmology
www.techmology.net
SexDrugsOverclocking said:
I believe three of us have asked this, what is the secondary error code?
Click to expand...
There is no output from the console and 1,2,4 LED are blinking and red.

I have checked. R7R17 is ok. Before putting the capacitor it was ok. I did not touch any connection after that. I have disconnected all the cable upside and downside both. Now stock nand has been written but same 1,2,4 RED light flashes
 
You must log in or register to reply here.