I just installed a Demon into a Falcon, w/ Rjtag and have encountered some odd behavior in regards to stock nand booting.
After install, I check, the stock did boot fine. Then I went to dump it. First dump successful and as soon as the 2nd dump started, it began to rrod, with 0020.
Very odd, but I let the dump finish and confirmed match.
I pulled power, let it sit a minute, reinserted power and did a double dump again, no issues this time.
I flashed stock to demon side, this also did a 0020. I pulled power, waited, and took a few tries to get it to boot normal.
I proceeded with Rjtag, xell booted no prob, flashed freeboot no problems.
Freeboot boots fine, I got a Legend score, good enough for now.
Now heres the deal, if I plug in the power cord fresh and switch to stock nand, it will 0020.
If I go for freeboot , and once it glitches, I can switch to onboard stock nand and it will now boot fine.
Ive jumped between both a few times, then tried stock, no problem.
I let it sit 20 mins, stock booted fine.
If I pull the power cord, now stock will 0020 until I get the system to glitch at least once.
Side note, whats the procedure for the Kiosk wire after rater? remove from rjtag? Leave it?
When I finished all this I put the kiosk wire back onto the demon, and left it on the Rjtag and had odd behavior.
As soon as I plugged in the power cord, the power led would blink once very briefly, and the rjtag debug light would begin, even though no solid power light on. If left alone for 1-3 cycles it would glitch and come on.
If I toggled to stock it would auto try to boot and then 0020.
I removed the demon kiosk and this behavior stopped.
After install, I check, the stock did boot fine. Then I went to dump it. First dump successful and as soon as the 2nd dump started, it began to rrod, with 0020.
Very odd, but I let the dump finish and confirmed match.
I pulled power, let it sit a minute, reinserted power and did a double dump again, no issues this time.
I flashed stock to demon side, this also did a 0020. I pulled power, waited, and took a few tries to get it to boot normal.
I proceeded with Rjtag, xell booted no prob, flashed freeboot no problems.
Freeboot boots fine, I got a Legend score, good enough for now.
Now heres the deal, if I plug in the power cord fresh and switch to stock nand, it will 0020.
If I go for freeboot , and once it glitches, I can switch to onboard stock nand and it will now boot fine.
Ive jumped between both a few times, then tried stock, no problem.
I let it sit 20 mins, stock booted fine.
If I pull the power cord, now stock will 0020 until I get the system to glitch at least once.
Side note, whats the procedure for the Kiosk wire after rater? remove from rjtag? Leave it?
When I finished all this I put the kiosk wire back onto the demon, and left it on the Rjtag and had odd behavior.
As soon as I plugged in the power cord, the power led would blink once very briefly, and the rjtag debug light would begin, even though no solid power light on. If left alone for 1-3 cycles it would glitch and come on.
If I toggled to stock it would auto try to boot and then 0020.
I removed the demon kiosk and this behavior stopped.
