i did the transistor wiring but used the original ROL (actually ROL point on the under side of the board) and DB1F1 points (same as the diode method) made a dash 9199 freeboot and worked every time.... well until i wet to take the X-clamps off and my tool slipped and knocked off 3 of those little square things under the left ( if lookin at the top side of the board front of board towards you, i think its the GPU with the 2 square silver surfaces) chip bridged than i got RROD bridged those and still got RROD need to seek professional help with that board now :/ , hopeing is something Xmods can fix
to be more exact it square thingy part #'s C4R5 C4R7 and a smaller green one labeled below it R4R3
luckily i just bought 2 RROD systems how ever that i know 1 i JTAG'able (dumped the NAND and its a xenon) and still need to check the CB # on the new zephyr but its MFG date is 07 and the dash is also the right kernal
hell the xenon has been RROD for so long it has the 1st dash on it still (the one before the advatars)
i just tossed them in the oven for about 10 min (before the capacitors started to dome up) pulled em out put syncs back on and they started back up, wont be able to actually use them until get a 5pk of team xecuter RROD II repair kit's tho because obviously the X-clamps will just cause another RROD and lets face it throwing the board in the oven is not much diffrent that following the team xecuter directions for there "baking process" 4other than the fact there baking process heats only the chips the oven heats all components (potentially a hazard if not cautious) but just for sh*ts and giggles i will probably follow the "baking" process instruction also a lil extra heat on the CPU/GPU to reflow the break (especially proven working methods) never hurt any thing.
