[UK] Oggy or someone else Needing my rgh fixed glasgow or surrounding areas

[Fizzy]

I am looking to get a wire resolderd to the motherboard gray wire from solder point b cr4 mod chip or can someone help and tell me where to solder it too it's a falcon mb

 

[johnnycalhoun25]

do you have the qsbs installed or are they just wired

 

[Fizzy]

I don't think there Is any qsb boards installed oggy installed the cr4 chip

 

[johnnycalhoun25]

look here http://team-xecuter.com/forums/showthread.php?148878-CR4-R-Jtag-Install-Diagram-(Wires-Only)

 

[Fizzy]

Thanks would that mean I need to take off the heatsinks i rrod another xbox a few years ago taken of the heatsinks

 

[johnnycalhoun25]

what point are you looking for

 

[johnnycalhoun25]

the grey wire to dont have to take off the heat sinks

 

[Fizzy]

Gray cr4 point b wire to r4b24

 

[johnnycalhoun25]

that is near the hana chip top side

 

[johnnycalhoun25]

off of my falcon

 

[Fizzy]

Ok great thanks for your help

 

[johnnycalhoun25]

no problem anytime

 

[Fizzy]

Think I will get the resolder from oggy or someone with feed back that solder point is real small

 

[johnnycalhoun25]

Think I will get the resolder from oggy or someone with feed back that solder point is real small

Yea it's a pain a lot of people mess up on that point. If you wind up lifting the pad you will have to scrap the trace and use a 33omh resistor

 

[Oggy]

Replied to your pm.

 

[Fizzy]

Thanks again oggy

Offers a Great service

*got oggy working on my xbox no replays needed*

 

[Oggy]

Shame youre so far away John, postage makes such a simple task expensive Will solder the wire in the morning and get her to post it out before she goes Peterborough for the day.