Okay...

[bendakov]

So I just finished modding the xbox 1.0 with the 2.6 CE... the settings inside show me that the F: has 0 space. It has evoX installed and I tried running a format disc, I also formatted through FTP commands on FlashFXP. The jumper is set to master like it's supposed to be. In the end the F drive still says 0 space.

I'm posting this here because this is the first time I've got this problem and it's the first time I'm using the 2.6 CE chip. I've formatted before and no problems.

Can somebody offer me any advice or suggestions if I went wrong somewhere?

 

[Martin C]

More information is needed here - what HDD have you installed?

Martin

 

[JimBobUK]

The jumper is set to master like it's supposed to be.QUOTE]

errrrrmmmmm as far as i know it should be set to CS

 

[Martin C]

Differs with HD models - either Master or CS will work.

Martin

 

[baztheman]

hi m8 it wouldnt harm to change the jumper to cs and make sure the 1024 limit jumper is not on,also get back to the forum with more info on what the drive model is you are using and the flash that is on your 2.6ce

heres a good site for checking if you harddisk is ok too
h**p://xboxdrives.x-pec.com/

some usefull software....
xboxhdm (heres a read me on it)

ps get some advice before using any software on your harddisk as most harddisk software has disclamers "if you damage it, it aint our fault" same goes for me and most likely the forum too.

your best 1st steps is to get back to someone like martinc who knows a lot on the xbox but help him help you by giving him more info on what hardware you have.......baz

 

[ttall8ball]

Need hdd model, stock or replaced etc..