I have a Jasper console that I installed a nand-x v1 qsb board to read the nand long before there was an RGH hack. Can I leave that on and just direct wire my 5v for the cr4 to do an RGH2 or do I need to get a v3 qsb? I know that the old v1 doesn't have com port monitoring so it'll take longer for me to fine tune the glitch. Just wanted to make sure there wasn't anything else that the qsb v3 adds other than that.
Old Phat Nand-X QSB V1
- Thread starter ssanders1970
- Start date
BL4K3Y
VIP Member
You can use the existing QSBs for NAND read/write.
For the record, COM monitoring doesn't monitor POST (which is what RATER uses).
If you decide to go with R-JTAG+, be careful when you solder "A" and "B" because those solder points are tiny and very easy to lift if you are not careful.
For the record, COM monitoring doesn't monitor POST (which is what RATER uses).
If you decide to go with R-JTAG+, be careful when you solder "A" and "B" because those solder points are tiny and very easy to lift if you are not careful.
Last edited: