Orig.bin not found

[Phill]

OK I finally get around to flashing my 360 Drive, because I got a new PC with SATA Cables. Here is the problem. I created a USB boot disk (drive what ever you want to call it) and once I type in

samread ------- ------ (I put in my real serial code)

It starts to read then it says ORIG.BIN not found. I been looking around and I don't know if I have to create orig.bin or what. I also tried MTKFLASH it says my drive is not connected (even though it is), I have my 360 on and every thing. Why is it doing this.

I have a Intel(R) ICH8R/DO/DH SATA RAID Controller. So what is the problem?

 

[xosux]

Mine said this when I had already read the orig.bin. Have you tried using a floppy?

 

[hubbley2k]

have you followed the tutorial to the letter?

 

[Phill]

I have, I tried many different ways. Here is my exact board.
Intel(R) G965 Express Chipset
So what do I do? I hex edited MTKFLash. I am going to try a couple of different ways also.

 

[xosux]

Sounds to me like you have an MS28. You need a VIA 6421A chipset (on ebay). I have an Intel 975x, our Intel boards don't work with an MS28.

 

[Phill]

Ok another thing. My chipset doesn't have a setting to were I can turn of RAID. IT has a setting to were I can change to RAID/ATA (I tried that also). It just recognizes what it put into my pc via sata. I can't turn of RAID so what do I do now. My sata is directly hooked into my Chipset.


Edit:
No I have a ms25.