RGH Original Nand Not working !

[AMIT]

:facepalm::facepalm::facepalm:Soldering is all ok,

at a time i flashed my nand with xell & nandflash.bin(hacked) ,result- 1 time boots the dash then it give me E68 ,after i flashed my original it gives me E 79,all hardware was removed ,HDD,DVD drive,4 GB internal memory ,Please Help me !

 

[asagoren]

Re: Originsl Nand Not working !

ldv ok? nand flashed with nandx or rawflash? original nand files compared?

 

[Martin C]

Pics of your soldering.

 

[paul.86]

If everything is removed you have damaged something check for solder splashes bridges bad traces
That's why pics are neccessary

It's hardware

Sent from my HTC Vision using Tapatalk

 

[AMIT]

Re: Originsl Nand Not working !

check this,same(me and he is doing this togather)

For god shake help us !

 

[paul.86]

Soldering does look good have you tried a rewire

I know I say it a lot but it has worked wonders in the past
Sent from my HTC Vision using Tapatalk

 

[Martin C]

Re: Originsl Nand Not working !

check this,same(me and he is doing this togather)

For god shake help us !

then post in the request a service or item and get someone to do it for you. It's obvious you're doing something wrong or have done something wrong.

 

[shinji257]

Re: Originsl Nand Not working !

If you get E79 after flashing the original then you probably didn't do it right. You have to flash using -w and not +w. +w causes E79 error when flashing an original nand back on.

i.e. (probably 16mb nand?) nandpro usb: -w16 filename

 

[alicine]

u must write your originalnand with below command

nandpro usb: -w16 originalnand.bin

i used +w16 (like ecc) i got e79.