Panel problem

[Xbishop]

I installed my X3 today, I have one problem when I have the yellow cable that controls the power and eject button plugged into the passthrough. The Xbox turns on by itself and the chip is disabled once I bypass the panel it boots right up to the Flash Bios screen. I checked all the wires and they are all right...

Has this happened to anyone?

 

[scottevil]

there has been some people with problems with the power/eject board, pull the tape off the bottom of the board and look for solder bridges between the connections.

 

[Xbishop]

That’s what it was pins 1 & 2 were bridged. I removed the solder with a Desoldering braid and booted up just fine.


Thank you,
I should have thought of that.

 

[Insectgod]

spoofing question

So i have a modded 745 liteon and i modded it to LT from dummy from ixtreme... you can't get the key from LT firmware from ixtreme... I have my key saved, but the last save I have is from when it was 1.51.... does it matter that the original firmware says it is 1.51 firmware where it really is LT... everything else is good.. it says it is the correct drive and all and correct key...

 

[wingheart]

Re: spoofing question

no it does not matter that it 1.51 as long as you have the key the original key you can make a new original F/W if you wont to put it back to stock

 

[Insectgod]

Re: spoofing question

i modded it again, but it said it was the 1.51 going to the lt 1.1... is that ok still??

 

[Insectgod]

Re: spoofing question

bump