RGH pcb board damage or a nand issue causing red light boot.

[Gumby8989]

I am not sure where to post this so I will try it here. I recently was going to put my new ltu2 board into my corona v1 slim. When I tried to boot it didn't go, it just had a red light and no video. I then noticed some damage on the bottom of the board and am not sure the values of the resistors that were knocked off. Can anybody point me in the right direction to fix this?

 

[bryce1733]

To me it doesnt look like missing resistors, and all i have to check against at the moment is a trinity, if they were missing i would think they would beat up the points a bit more then that. Id take a multimeter and check the traces for continuity as it looks like some of them may have been cut. Good luck!

 

[Gumby8989]

they had actually been broken off I cleaned up the pads there is supposed to be resistors all across those points