RGH Phat CB_A 6750 nands does not match!

[GodsSon07]

Hello everyone.
Thanks guys for the the help that you are giving us. Mst of the time i read here to learn, but now, i cant solve this issue that i have.

I extracted like 10 times my jasper 16 nand, and their all mismatch.
It gives me one bad block sometimes error 250 block 233 or 258 block 233.

A pic from 360flash tool:

Any help?
Thank you:frown:

 

[XBOX4LIFE]

Post pics of your soldering, that'll be your problem imo

 

[GodsSon07]

thanks for replying.
I did it 2 times. When i solder it the first time, same errors. And when i solder it the second time, again, same errors.
Ill post a pics

sorry but this is all i can get

http://img269.imageshack.us/img269/1016/26472863.jpg

 

[keil423]

You using QSBs or direct wireing?

 

[Krafter]

Your not powering up you console in between or during the read are you?

 

[GodsSon07]

Your not powering up you console in between or during the read are you?

Nop.
here is the pic

 

[AteOeight]

Try using a multi meter, bad blocks as stated, are usually caused by a weak solder point. Can you get us more pictures of your soldering i.e. wire to points, please? It'll help out with troubleshooting.

 

[madman46804]

if you have an actual bad block then you will likely never get 2 dumps that match perfectly error 250 seems to indicate that this is the case as long as its not in the first 50 blocks this should not present any problems

 

[Vest1ge]

Also your not turning on or off anything else on the same circuit during the reads?

Just turning off your soldering iron can give you bad blocks...

 

[XBOX4LIFE]

Your not using TX tools, would m$ help you fix your ps3 ?.... Closed