Please help - error 0x0002 when update cr

[talm1977]

Image below -

Happens when i try to update the cr with the nand-x.

 

[Lizardpcs]

What program are you using to flash the glitch chip?

Things to check
-wires are in the correct order on your update cable (a small number of cables were shipped with the wires around the wrong way)
-Check your Nand-x plug (we had one that was solder 1 pad out)
-If you coolrunner is already installed in the Xbox make sure you flick the switch to PROG

 

[talm1977]

I use NandPro.exe to update the cr with the nand-x:

NandPro xsvf: Jasper.xsvf

 

[Lizardpcs]

I use NandPro.exe to update the cr with the nand-x.

You do have the xsvf files in the nandpro folder don't you?

NandPro xsvf: MOTHERBOARD TYPE HERE.xsvf

Try Coolshrimps jtag tool to flash the coolrunner

Check your wires if all else fails
Wires whould be like in the picture in this post
http://team-xecuter.com/xecuter-coolrunner-now-in-production/

 

[talm1977]

I've tried Coolshrimps jtag and coolrunner flash tool,
but nothing.

When i plug the cr into the nand-x, BEFORE the programming, there's no green light, only red (and it was never been programmed before).

Thanks.

 

[BL4K3Y]

You won't see a green LED until it has been programmed - is the switch on the CoolRunner set to PROG?

Can you post an image of your cable?

 

[afsilver]

I thought the green light would glow until the cr was programmed, then it would only have the red light after programming?

Sent from my GT-I9100 using Tapatalk

 

[BL4K3Y]

I'm going from memory, I am fairly sure that the green LED is inactive until the CoolRunner is programmed.

 

[mafia 5k]

try getting in the root of nandpro using this command CD nandpro30

then you should be seeing somthing like
cd: user\nandpro30

then try command nandpro xsvf: <motherboard type>.xsvf

it never works for me unless im on root of the folder in cmd

---------- Post added at 06:35 ---------- Previous post was at 06:34 ----------

I'm going from memory, I am fairly sure that the green LED is inactive until the CoolRunner is programmed.

green light should be glowing if not programmed once it says complete the led will then turn off...

 

[BL4K3Y]

Thanks for clarifying, I need to get me some more CoolRunners........ I haven't used one since mine when they were first released :tongue:.

 

[mafia 5k]

No problem, easy to mix up.

by any chance could you post a picture of the coolrunner to nandx cable while plugged into your CR, just to make sure its not upside down or if any pins broke.

 

[crazyyyk]

Please help!
Chip was preprogrammed for Jasper, but I tried to programed it again with nandpro3 (just for test), and I've got File execution FAILED! Status :0x0002.
I wanted to ask, could I erase firmware which was in glitch chip? Can I now use it? Or I need programming it without errors?
Thanks

 

[talm1977]

Thank you all,

here is an image as requested: