Hey guys, I have a v. 1.0 Xbox along with an xecuter 3 CE and Xapt3r which I got in the mail today. I installed everything fairly easily and I finally got to flashing my bios. I'm sure that this has been asked and probably answered 20,000 times in the past but I've looked everywhere and can't seem to find the answer as to what I need to do to get going here. I'm a complete noob to modding xbox's so please bare with me.
I installed the flash bio's 3.0.3 via HTTP. It says flashing bios, they flash, and then the xbox shuts off. When I turn it back on, it brings me back to that dreaded blue screen rather than the "rox my box" thing.
I don't know anything about the MB stuff, banks, etc. So if anyone could just tell me...
Flash Protect: Enabled or Disabled (Disabled Im assuming. Red light on the chip, yes?)
Which buttons do I need pushed to the right on the switch. (On, On, OFF OFF OFF is what I was doing.)
Am I missing anything important?
Any help would be appreciated. I've been working on this thing for almost 9 hours now and I would hate for it to be a waste.
Thanks alot guys.
-Evan
I installed the flash bio's 3.0.3 via HTTP. It says flashing bios, they flash, and then the xbox shuts off. When I turn it back on, it brings me back to that dreaded blue screen rather than the "rox my box" thing.
I don't know anything about the MB stuff, banks, etc. So if anyone could just tell me...
Flash Protect: Enabled or Disabled (Disabled Im assuming. Red light on the chip, yes?)
Which buttons do I need pushed to the right on the switch. (On, On, OFF OFF OFF is what I was doing.)
Am I missing anything important?
Any help would be appreciated. I've been working on this thing for almost 9 hours now and I would hate for it to be a waste.
Thanks alot guys.
-Evan