Please Help! Original Xbox needs new mother board and I need Xecuter instructions

M

mblaa

Full Member
May 29, 2005
25
0
OrigXboxXecuter.JPGUnfortunately I installed this Xecuter about 14 years ago and I don't have the model but I need the instructions. Picture is attached. Is it possible to just change out the mother board on my original xbox solder back in the Xecuter and have my fully loaded hard drive work again?
 
Last edited:
M

mblaa

Full Member
May 29, 2005
25
0
After I created this post I found an original post from me when I installed it in 2005 and did figure out it was the Xecuter 3 CE.
I can't seem to find any documentation links that work.

The problem with the xbox according to my son is the video looks bad after it warms up, shakey, pixelated.
I have not seen it for myself yet but I assume it would likely be the motherboard.
 
M

mblaa

Full Member
May 29, 2005
25
0
I found a fully working original Xbox at the game store down the street with a controller and all cables for $49.00.

Before I go buy it the real question is can I just change the motherboard and reconnect the 3 CE and make it work.
What about the bios flashing?
 
You must log in or register to reply here.