Please Help!/QSB Question

[noah2300]

Well yesterday I finished installing my NAND-X Quick Solder Boards and I agree that it looks quite messy so I am about 99% sure that is why Jtag Tool is giving me the could not detect flash controller error. I was wondering if any of you pros out there could please tell me exactly where you think the error is coming from and exactly which point to re-solder? (pictures of QSB's at the bottom) Or do you think it looks so messy I should De-solder it and just use the pin headers? And if you think I should just use the pin headers, I was wondering what the tutorials mean by cutting off the pin header block.

Thanks

 

[optantic]

too much Solder!!!!! and all the points are suppose to be separate, but you connect them all together with solder!!
I would say desolder and try again

 

[CarolinaGamer]

WTF??? haha yeah way to much solder, like each points should be separate. Not just a big solderclusher****. Take it down to single points and you should be fine.

CG

 

[krier023]

also try using flux. for me it helps the solder ball in the right spot better. all you need is a little solder

 

[Kacosa]

holy sh*ttt! haha too much solder yea! big time!

 

[BGAMods]

this has got to be a wind up! surely anybody can see that the solder points need to be individually soldered.

 

[modmonster]

Desolder all of it. Use about 70% less solder when you redo it and use flux.
Take the solder off with a braid preferbly or a sucker.
If I were you id stay away from cutting the pin headers off as you'll have to solder the wires directly to the board which will require more skill than the qsb's.

 

[Kr4k 4 J4Ck]

Ok srry for bringing up a very old thread but i was on the last part of soldering for the Nand-X and i bridged 2 points and i cannot get the solder off should i turn up to 40W on the IRON and desolder with desoldering braid because i cant get the solder off with a 20W?

 

[TilVl]

You can, but risky. Be careful. Don't leave it on there to long and use flux.

 

[Kr4k 4 J4Ck]

Worked Thanks man i just had to be very careful