RGH plz help

P

pspv10

Full Member
Dec 16, 2011
78
18
hi

I was doing RGH and when i want to solder point B

I made a mistake





I give more heat and the capacitor or resister I don't know what it is pull out (which shown in the picture )

is it possible to replace it

the xbox is phat jasper 16MB
 
P

pspv10

Full Member
Dec 16, 2011
78
18
it is OK
i done like 40 RGH I know what im doing...
i don't know what is wrong with me today

can you tell me how to fix????
 
P

pspv10

Full Member
Dec 16, 2011
78
18
Mister_X said:
Cant tell you how when we cannot see what you damaged. post some high rez pics.
Click to expand...

the resistor shown in the picture is not there it get pull out

i have it in my hand but it can not be solder again

is there any replacement
 
M

Mister_X

VIP Member
Apr 13, 2011
189
0
Canada
Ok but we still need to see what damage has been done to the board.

Post pictures or you're probably not going to get any help.
 
ball00

ball00

VIP Member
Nov 8, 2011
632
0
France
That should be a 34ohm smd resistor. You can just replace it if the pads are still intact.

Just saw your post. They're not intact then. As above post pics so we can suggest suitable fix. Need to see whats left of your traces if there is anything left
 
Last edited:
M

Mister_X

VIP Member
Apr 13, 2011
189
0
Canada
That looks like the pads are fine. just reattach the resistor with a fine tipped iron and a pair of smd tweezers. The solder joint on the QSB on the other hand looks pretty bad. looks like its cold and you didnt use any flux.
 
P

pspv10

Full Member
Dec 16, 2011
78
18
thanx

this is a stupid question

do i have to use smd resistor

or normal resistor works
 
ball00

ball00

VIP Member
Nov 8, 2011
632
0
France
Either will work but you say you have the smd and if the pads are still there then I would go that way.
 
  • Like
Reactions: pspv10
M

Mister_X

VIP Member
Apr 13, 2011
189
0
Canada
a normal resistor will work, but you're going to have to solder some wire leads to it because its just not plausible to mount a through mount resistor to the board there. anyways if you still have the smd resistor just reattach it. use flux, fresh solder and a nice fine tipped iron. 15-25 watts should be all you need.
 
  • Like
Reactions: pspv10
P

pspv10

Full Member
Dec 16, 2011
78
18
actually the smd resister i have is ruined it cut in half

this is very old xbox i just touch it and get pull out


im gonna try with normal resister and hope will make it work

thanx alot guys
 
P

pspv10

Full Member
Dec 16, 2011
78
18
done
it is working....

thanx alot guys

here a picture after installing the resister



maybe it will help some one in the future with similar problem
 
You must log in or register to reply here.