POGO MO THOIN PMT Hack - No Cap required, Just a CK3 and a switch :)

Ubergeek

Xecuter Groupie
Feb 24, 2003
6,261
0
California, USA
Re: Show us your skills! PMT pics

No cap required - just a ck3 pro (or lite) and a switch across the 3.3v line :D

Thanks to Cypher21 !

1. CK3 Main Power ON, 3.3v Switch ON
2. Press the PhatKey button, then click Yes
3. 3.3v Switch OFF, connect probe to MPX01, 3.3v Switch ON
4. Wait until Extract Complete, now remove probe from MPx01
5. Switch the 3.3v OFF then ON then click OK

job done :)





Also:

Red/Brown wire joined to 3.3v line
Black wire straight to ground / probe






Geremia said:
 

dec0y7

VIP Member
Apr 15, 2010
160
0
Sheffield uk
everyone is trying to go for the most compacted or the most simple, and i like simple :) so my next 1 will be simple
 
  • Like
Reactions: 360royalty

Twinbird

Senior Member
Feb 9, 2010
124
18
Canada, ON
This is awesome! Thanks so much!
Built one in about 10 minutes from spare parts, here's a pic:



Tested it with two LiteOns right away, no problems! :D
 

dcstewart_2009

VIP Member
Nov 4, 2009
160
0
N. Ireland
Do we need to strip the components off the the CK3 V1 to do this, or is it safe enough just leaving them on?

Also, what wire is connected to the probe? Any chance of a close up shot of the connection for us electrically challenged folk?
 
Last edited:

Jahaziel

VIP Member
May 28, 2010
177
0
Bradenton, FL
I have a ck3 pro, probe v2 and a switch I just picked up. What setting do I put my probe in to read the new point??
I just wanna make sure, I believe it's gonna be in probe.
Mra or probe?
 

Jahaziel

VIP Member
May 28, 2010
177
0
Bradenton, FL
i reread it, i have put the switch on the 3.3v line like it says. have the probe set on probe instead of mra, and the op switch pressed (standby off). did as instructed and worked!!!

awesome that this works!! thanks to everyone that made this possible =)

ps i had issues cause the switch wasnt fitted right