I forgot to rename the bios to bios.bin when I flashed. I used banks 1 and 2. When the green bar finished, it said, "Flashing failed". I restarted the box on the banks I flashed; nothing. The backup bios wont even work. I tried it with them all the way to the left to load flashbios; nothing. MS BIOS works fine. I can boot halo 2 and whatnot on it. But I can't load flashbios anymore. What should I do?
Possible screwup due to not renaming file
- Thread starter Computertrendy
- Start date
Martin C
VIP Member
then the mod needs fitting correctly as something has obviosuley come loose or shorted maybe ?Computertrendy said:
probe 2 help
I am trying to flash a Liteon 93450 c. I have a probe 2 fitted to a ck3 pro. I am stuck at the first step. I cant get my drive seen by JF. I have cut the traces and tested them for no continuity. I have cleaned the 2 holes nice and clean. When I touch the probe onto the holes and power up the ck3 pro,I just cannot find the drive. This is the first 93450c I have done. I have done plenty of other drives.
Dose the probe need to go right into the holes? Also I'm using the V cut method as on the JF tutorial, dose the trace that is attached to the hole only need to be separated from the hole, or dose the trace need to be completely cut? I have cut it completely
I am trying to flash a Liteon 93450 c. I have a probe 2 fitted to a ck3 pro. I am stuck at the first step. I cant get my drive seen by JF. I have cut the traces and tested them for no continuity. I have cleaned the 2 holes nice and clean. When I touch the probe onto the holes and power up the ck3 pro,I just cannot find the drive. This is the first 93450c I have done. I have done plenty of other drives.
Dose the probe need to go right into the holes? Also I'm using the V cut method as on the JF tutorial, dose the trace that is attached to the hole only need to be separated from the hole, or dose the trace need to be completely cut? I have cut it completely
Re: probe 2 help
I have answered my own question. The top trace must be intact. After a little more reading I found this out and all is sorted
I have answered my own question. The top trace must be intact. After a little more reading I found this out and all is sorted