RGH Post_out1

[skater411]

i need to know how to repair post_out 1 i have repair stby_clk before . i seen how to repair the post_out1 but i was wondering where the other end of the wire go i seen where you scrap an tin an solder wire to it then put glue over it but where does the other end of wire go where do u solder the new post out 1 point ?

 

[AMIT]

Check Here !

 

[skater411]

im trying to post a picture but it not allowing me

 

[AMIT]

im trying to post a picture but it not allowing me

Try this !

 

[skater411]

yeah i know that i seen that guide but im asking where the rest of wire go

 

[skater411]

http://imageshack.us/photo/my-images/513/img0863nh.jpg/


where im asking is how do i go about repair this trace in the picture it only show the wire solder from one end where the other end go

 

[TilVl]

Top side. Or run trace to coolrunner then to alt point.

Sent from my SGH-T839 using Tapatalk

 

[KhaineGB]

Looking at the guide, it would appear the wire just goes straight to the CR.

 

[skater411]

but the other post-out 1 point it does not need to be nothing done to it

---------- Post added at 21:36 ---------- Previous post was at 21:31 ----------

ok can someone please guide me what to do

 

[skater411]

never mind i get it

---------- Post added at 21:50 ---------- Previous post was at 21:47 ----------

so i got second error code . is that why bc that post_out 1 broke

 

[KhaineGB]

What's the secondary error code? And have you programmed your NAND with an ECC or hacked image yet?

 

[skater411]

ok can someone please explain to me in detail how to repair this thx

---------- Post added at 22:16 ---------- Previous post was at 22:15 ----------

i had it all up an running an working right an i screw up on update

---------- Post added at 22:17 ---------- Previous post was at 22:16 ----------

my post out 1 look like it damage to me

---------- Post added at 22:23 ---------- Previous post was at 22:17 ----------

never mind fixed it