How do you change the postbit jumper to 10Ohms or 100Ohms like do you pull it, push it or what because im kind of nervous to do whatever to it because i dont want to break it. I've already installed the CR4, i just want to see if I can get better boot times. So far my boot times are like 1-6 glitches. I just want to cut it down to 1-3.
Postbit Jumper Quick Question
- Thread starter IneedHelp101
- Start date
ultimate360
VIP Member
You pull up on the small black plastic piece and it lifts right up off of the pins. Then you can slide it onto another 2 pins right next to it, and then the last set of pins. This will allow you to change it and try the different settings
