JTAG Power brick turning red when pressing main power swicth of xbox 360 console
- Thread starter rishank
- Start date
no bro he does'nt swaped my motherboard beacuse there is my name written over there on xbox 360 chip
let us hope that
mofset can ran my console :smile:
and one thing more shall i buy mofset of same serial number [mosfet #fdd8782] from near my market of electronics it will work
Last edited:
crashxtrme
Full Member
Part number was NTD60N02R for xenons, falcons don't remember, usually that mosfet provides power to the usb drives. 360 does not work if shorted.
Get the part locally from some other motherboard, as it seems you want to repair it all by yourself.
I can send it to you 400 inr including shipping. Confirm and ill pm you the link to pay.
Yup falcons are fdd8782,
Get the part locally from some other motherboard, as it seems you want to repair it all by yourself.
I can send it to you 400 inr including shipping. Confirm and ill pm you the link to pay.
Yup falcons are fdd8782,
Last edited:
i am checking that mofset in my local market if i'll get i will tell otherwise i'll pm you
hersheys247
VIP Member
Why not just get it from the guy in the post above yours he's in India, anything from the states to u is going to be more in comparison
I have been bust with work & can't get off before they close, the is the exact part# on the mosfet
-------------
732 OH
48
13NHG
--------------
On the right side it has OH with a circle around it..
-------------
732 OH
48
13NHG
--------------
On the right side it has OH with a circle around it..
Last edited:
i've been working late and cant get to the post office before it closes.
The part number I listed in my last post is the part# of the mosfet if you want to try to find it local..
The part number I listed in my last post is the part# of the mosfet if you want to try to find it local..
he might be busy right now too, or mad because you should have gotten the part you needed right then.
Could be a GPU issue there buddy. Find out what the error code is. Its not uncommon for people to bend/twist the board accidentally when removing it. If so, you are looking at a reflow / reball. Sorry for the bad news.
first thing first replace mosfet op then go from there. I was just wondering is it a record for the most post on one thread. just wondering??
i am not enjoying what i've doing here:frown:
i just want to sort out my problems
john mathews
VIP Member
lol um still waiting on slim hard drive cover dont believe this guy hell i would of paid for it
Last edited:
john mathews
VIP Member