RGH Power light wont go off on PGR and no glitch

[daman10]

Got a RGH 1 Jasper glitched to xell got cpu key etc wrote freeboot image booted fine, put xbox back together now no debug light. I wrote stock image back put CR3 to PGR and theres still a faint power light, and it wont boot throws 0002 error, if i take off STBY_CLK the power light goes off and it boots to stock.


I have tried resoldering all points and even tried alt STBY_CLK but no luck.


Any ideas whats causing this?

 

[moco]

Firstly the only thing I can think of is to re-programme the Coolrunner as I've seen in the past as its happened to me that it must have corrupted somehow. The other thing I suggest is to use the top stndby clk as per instructions. If using the top doesnt get the chip to glitch, you can also try unbridge lk1 and use the onboard clk on the cr3 lite.

You can also try replacing the (B StndbyCLK) wire it's possible you have a break in it.

Or remove all wires and start again. If it's still botting stock, then the issue isnt on the Xbox itself, but on the CR3 or wiring.


Sometimes weird sh*t happens.
http://team-xecuter.com/forums/showthread.php?t=92428

 

[daman10]

Firstly the only thing I can think of is to re-programme the Coolrunner as I've seen in the past as its happened to me that it must have corrupted somehow. The other thing I suggest is to use the top stndby clk as per instructions. If using the top doesnt get the chip to glitch, you can also try unbridge lk1 and use the onboard clk on the cr3 lite.

You can also try replacing the (B StndbyCLK) wire it's possible you have a break in it.

Or remove all wires and start again. If it's still botting stock, then the issue isnt on the Xbox itself, but on the CR3 or wiring.


Sometimes weird sh*t happens.
http://team-xecuter.com/forums/showthread.php?t=92428

Thanks i have tried to reprogram the CR several times also built new glitch images and resoldered them pics are after several attempts, i was first using the top STBY_CLK point but switched to the ALT to rule that out, with LK1 enabled the power light goes out when the CR is set to PGR and boots stock as normal.