Pre Nxe Xenon NAND Issue

[crazed-cracker]

I have installed the wires properly. They are through the console. When I click read nand this comes up:
Flash Config: 0x00000000
Can not Continue
Can not continue
Version: 03

Here are pics of the install. It turns on normally and boots to 6717 but for some reason I cant read it.

 

[BL4K3Y]

I suggest you re-solder those wires.

Heat each pad up, feed the wire onto it and it should "drop" into the hole.

Have you installed your NAND-X drivers correctly?

 

[crazed-cracker]

I suggest you re-solder those wires.

Heat each pad up, feed the wire onto it and it should "drop" into the hole.

Have you installed your NAND-X drivers correctly?

Yes I havent used the NAND=X in about a month or so but it was functioning properly before. When I plug it in the logo appears on J-Runner. I reinstalled the wires but still nothing

 

[BL4K3Y]

You might want to read this.

Just to be clear, you have got the power brick connected to the console?

 

[playingmax]

I suggest you re-solder those wires.

Heat each pad up, feed the wire onto it and it should "drop" into the hole.

Have you installed your NAND-X drivers correctly?

yes. remove wires, add more solder then re-solder also dont forget to use flux.

 

[crazed-cracker]

I have taken the wires out and reinstalled a new pair on the underside of the board. Still nothing. Any advice?

 

[Martin C]

Yes - read my NAND-x troubleshooting guide.