probe 2 as sputnik probe

jpoy808

VIP Member
May 2, 2010
313
0
usa
can you use probe 2 on the 0225 slim in replace of the sputnik probe to write the Lt 1.9? Or will probe 3 work?
 

jpoy808

VIP Member
May 2, 2010
313
0
usa
So u solder the 10 ohm resistor to the ground then connect a probe? What about the wire , what u recommend ? What part from pi u from also pinoy
 

cypher21

VIP Member
Jun 15, 2005
169
0
Netherlands
i said i hold it to the probe, i'm not soldering anything

Probe 3 = ground,
hold one point of the resistor to the probe, other point to pcb and it's unlocked.

@rome, are you really gonna be the spelling nazi??? :facepalm:
 

jpoy808

VIP Member
May 2, 2010
313
0
usa
Will probe 2 work with this method? If so what are the settings on the probe and which pin to use on the probe
 

jpoy808

VIP Member
May 2, 2010
313
0
usa
So let me get this right, solder one point of a 10 ohm resistor then connect other end to the point to probe correct
 

cypher21

VIP Member
Jun 15, 2005
169
0
Netherlands
:facepalm:
This is mentioned in all the tutorials
You either solder one point to ground, (i told you i don't solder but only HOLD it to ground) and then touch the point to unlock it