Probe 3 Com Port Not Being Seen On JungleFlasher

[HungrySage]

I'm trying to flash a 9xxxx series liteon drive, the X360USB pops up just fine as well as the drive, but my com port for the Probe 3 is not being read. any ideas?

Edit: Also, the LED 5 turns off and LED 6 turns on when i turn on jungleflasher.

 

[manwithoutname]

Probe 3 does not require any com ports.

 

[HungrySage]

Why does the phat key extract keep failing? its a 93450c with the old firmware, not the the updated firmware.

Edit: Even though if its a 93450c, should I do 1.1 LT or 1.9?

 

[manwithoutname]

Which point are you probing with the probe?

 

[HungrySage]

MPX01, and strangely after restarting the computer and reconnecting the usb pro, it read the key fine. So for a 93450c (not 02510c) i should flash it with 1.1 or 1.9?

Edit: because jungleflasher 1.84b is autoloading 1.1...

 

[bdh1689]

if you have the new dash (13146) you need to flash to LT 1.9... if you have the old dash you need to update first the dashboard.

I see you have a 93xxx so you need to update first, when you connect again the drive to jungleflasher it will be detected like 0251, then you can flash the 1.9

 

[HungrySage]

oh man, i gotta put everything together again to do that, thank!