FIXED Probe 3 fault?

Johnyb62

Noob Account
May 18, 2006
6
1
Hi
Trying to extract drive key from DG16D2S and having problems. At first I could get no further than an error after the resending vendor intro. Rather an using the switch on the probe cord, I powered off using the CK3i power switch, and which then took me to the next stage where i need to remove the probe and power off for 5 seconds. Now I tried using the probe cable and the LED didnt go out, so I tried using the power switch again, but the extract fails
Sounds like I have a problem with the probe cable somewhere, does this sound right? Is there anyway I can fix the cable, maybe replace the switch?
 

Johnyb62

Noob Account
May 18, 2006
6
1
Shame that noby replied to this, but I took a punt and purchased a new switch, soldered it in - and the process worked fine. So must have been a faulty switch