SPUTNIK - PROBE Probe and PCB Question

17481

Senior Member
Feb 16, 2013
138
0
Do you have a Winbound or MXIC chipset?
Dang, i need to read more then. I dont know what either one of those is.

---------- Post added at 01:08 ---------- Previous post was at 01:05 ----------

Do you have a Winbound or MXIC chipset?
I just learned that its is also another specification of your DVD drive, how can i tell which one it is though?

---------- Post added at 01:12 ---------- Previous post was at 01:08 ----------

Dang, i need to read more then. I dont know what either one of those is.

---------- Post added at 01:08 ---------- Previous post was at 01:05 ----------


I just learned that its is also another specification of your DVD drive, how can i tell which one it is though?
I have the drive in vendor and have retrieved dummy.bin on jungle flasher. Reading this is the only way 100% to know for sure, where does it say in jungle flasher?

---------- Post added at 01:17 ---------- Previous post was at 01:12 ----------

I just was reading though the jungleflasher logs and it says flash name: winbond

So winbond is your answer

i apologize for all the posts
 

daretogo

VIP Member
Feb 4, 2011
297
0
Denver, CO
I just was reading though the jungleflasher logs and it says flash name: winbond

So winbond is your answer

i apologize for all the posts
Winbound is your answer. :biggrin:

You need to spend some more time in the Jungleflasher tutorial. Specifically look into the Kamikaze unlock or you'll need a replacement TX PCB.
 

17481

Senior Member
Feb 16, 2013
138
0
Winbound is your answer. :biggrin:

You need to spend some more time in the Jungleflasher tutorial. Specifically look into the Kamikaze unlock or you'll need a replacement TX PCB.
I have another board that is mxic. What about then if my drive is mxic?
 

17481

Senior Member
Feb 16, 2013
138
0
The JungleFlasher PDF contains all the information you need.

We also have a lot of helpful guides right here on the forum.
I press "User Guild" in Jungleflasher and i cannot download it. I believe that is the PDF.
 

daretogo

VIP Member
Feb 4, 2011
297
0
Denver, CO
I have another board that is mxic. What about then if my drive is mxic?
MXIC chipsets can be unlocked with the PMT probe. Requires trace cutting and soldering or installation of a switch, but is generally considered more noob friendly than kamikaze.

You can always go with the unlocked PCB for MXIC chipsets too.

And all of this IS in the Jungleflasher manual.
 

17481

Senior Member
Feb 16, 2013
138
0
It's in the "Documentation" folder.
I read and unserdtand it but have a few questions.

When i use the prob to i have to have a resistor going to a grounded point like in the image in the PDF for MXIC unlock without the MX PCB?

basically the second way to flash MXIC in jungleflasher.
 

17481

Senior Member
Feb 16, 2013
138
0
I read and unserdtand it but have a few questions.

When i use the prob to i have to have a resistor going to a grounded point like in the image in the PDF for MXIC unlock without the MX PCB?

basically the second way to flash MXIC in jungleflasher.
I will open up a new thread as this is a new topic. Please close this one.