Problem after flash

[DJravingMonkey]

I just flashed my X3 with 3294. Everything seemed to go right, the green bar appeared and the xbox turned off. When I fire it up now, it turns off again after some seconds...

 

[matt77303]

did you flash the correct version for your version of xbox? eg 1.6 needs the v-16plus version?

Matt

 

[DJravingMonkey]

yes I flashed the right version

 

[rockclimber]

If you're sure you got the right version and set the switches correctly then
check pins 13 and 14 are soldered good, these pins are only used after flashing.

 

[matt77303]

If you're sure you got the right version and set the switches correctly then
check pins 13 and 14 are soldered good, these pins are only used after flashing.

worth a look yes, but they shouldnt cause a frag, only a blank screen. what are you bank switches set at?

Matt

 

[DJravingMonkey]

on on off off off for 1 Meg @ 1 -4, right?

Just tried flashing flash bios v3.0.3 with on on on on off - works fine

will check pins 13 and 14 tomorrow... don't know what I could do else

 

[DJravingMonkey]

Ich resoldered pin 13, works perfectly now... so, remember wrong soldered pin 13 cannot only cause a black screen but a frag

 

[Imp Wiz]

This was my problem too. The solderless adapter did not sit right. This should be a stickey