LITEON 0225 Problem after updating 15574 dashboard...

[_andr3as]

The problem is that i didn't know about the new update 15xxx, so i first updated the console and then retrieved the dummy file.
Unfortunately i flashed the original board through the Sputnik probe and now i doesn't read even original xbox games...
The question: Is there anyway to flash the dummy file as an image (not been processed by lizzard or jungleflasher) so i can bring it to its original state????

 

[15432]

What error do you see?

 

[Fisticuffs]

Sounds like you have the wrong key or flashed it wrong, And nothing is wrong with Jungleflasher, Load your dummy.bin as target and flash.
Upload your jf.log file

 

[_andr3as]

I use lizzard to retrieve the key and jungleflasher to make the Custom Firmware file tried to write back the orginal firmware but nothing, PLAY DVD problem all the time...
I read that the new update of the dashboard have changed the protection of the drives...

 

[talby71]

as Fisticuffs has said post your JF log...
did you check the lizard site, since this a Team Xecuter support site

 

[_andr3as]

Sorry about the Lizzard thing but i used both of the programs and methods. With Jungleflasher i had problem writing the flash it stuck in Writing Bank 0: .
I am attaching all the logs that i tried to use.

I have flashed over 40 consoles (8 of them were slims) but i had a few months to flash one and didn't read about the new update...

I know i cannot read the cpu key with the new update so i am trying to figure out how to return back to its original condition...

 

[talby71]

you have your DVD key, you don't need the CPU key unless you are RGHing it
if you were using a USBpro with Jungleflasher you would probably have it sorted...i have no idea how the Lizard works and don't want to
it's not dash 15574 causing the issue

 

[x360ccm]

make sure you are using the right lt 3 for your drive.

LTPlus-0225-v3.0.bin if you drive is labled 0225 then use this one.

LTPlus-0225-v3.0u.bin is for drives labled 9504 but show up in jf as 0225.

 

[_andr3as]

FIXED the problem with the PLAY DVD guide (HEX EDIT THE 11FF80 line)...

dgenx you are correct but i already did tried that in my first attempts (i had already 2 consoles with this solution)

THANK YOU ALL FOR YOUR HELP!!!

 

[15432]

I think the problem was not fixed completely (try to reboot console for a few times)... If you see PlayDVD again please give the Dummy.bin