FIXED Problem Whit JR-Programmer dosent Write

[gLeW10]

Problem Whit JR-Programmer dosent Write [SOLVED]

hi i purchase a JR-Programer
Install the drivers
open Jrunner recognizes the JR and read the nand. everything perfect and reads well.

I make the ECC and to try to write on the nand and give me error.

Connect my nand-x and write perfectly,

Can you think of someone who can be?

The error are
Error: 000 Writing Block 0
IoTimedOut
Error: 000 Writing Block 1
IoTimedOut
Error: 000 Writing Block 2
IoTimedOut

 

[Martin C]

post images of soldering please.

 

[oO Elite Oo]

writing error, go to settings and change JR delay to 1 if that doesnt work then go with 2, 3 until errors are gone, but begin with 1.

 

[Martin C]

apologies - I didn't read the OP properly.

If NAND-x is working then it's the delay setting as suggested.

 

[gLeW10]

Thanks i try and coment here. thanks

 

[gLeW10]

writing error, go to settings and change JR delay to 1 if that doesnt work then go with 2, 3 until errors are gone, but begin with 1.

Hi thanks very much, i put the delay on 2 and works perfect.