Problem with coolrunner RGH2 Falcon
- Thread starter eventai
- Start date
Utmad
VIP Member
john mathews
VIP Member
Good luck getting that glue off without ripping a pad. Falcon RGH2 is a pain in the balls for your first mod. I would wait for the new CR4 chip to come out: http://team-xecuter.com/forums/showthread.php?t=145432
Always buy from one of TX's suggested re-sellers; http://team-xecuter.com/where-to-buy/
Always buy from one of TX's suggested re-sellers; http://team-xecuter.com/where-to-buy/
Last edited:
this is not TX produces its fake chip always but from Re-sellers and check the serial number
That is actully one of the worst clone/fake chips i have seen it dosen't even have coolrunner printed any where on the chip and the main chip is completely blank dosen't even have the Xlink like some of the "better" clone chips have.
I've upgraded system from clones to genuine gear, I must agree, this is one of the most crap quality clones I've ever seen. It looks like some inexperienced person has prodded most of the solder and left ugly marks, nasty.
THIS CLONE IS THE NASTIEST IVE EVER SEEN, Ive seen many and replaced them with genuine ones. I can say in this case, The clones I have replaced are superior to this one here.
Madness. If you were unaware this was a clone then you should demand your money back and some. Buy genuine and support the team.
EDIT:
RGH2 on phats (in your case falcon) is not that reliable, it can be done, but its better to wait for the CR4.
Out of many Falcons, I've managed to do 1 successfully with a decent boot time. Its not really worth the time to try, unless you have plenty of time on your hands.
Last edited:
rendis.adio
BANNED
Re: delete
This is support forum, you should post what you did to fix it.
There is no way back, deleting info and photos of your fake CR install doesn't hide your practices.
This is support forum, you should post what you did to fix it.