Problem with jasper

E

er0ck

Full Member
Jan 28, 2004
32
8
The problem is somebody decided to RGH their 256mb jasper without supervision. I personally soldered on the nand qsb and coolrunner. I also did perform a read of the nand to test the install.

This is where I left it.

An excited friend (his console) decided to finish the procedure. He upgraded the console to dash 13599 (official) and wrote ecc from previous dump. He failed to dump the nand again after updating. Then he wrote a glitch image for 14699. The unit would not boot flashing green light.

this is where I came back.
I am able to get it to boot to xell to get cpu key. But unable to create a working nand.

Any input on what may be able to bring this back?

Thanks
 
E

er0ck

Full Member
Jan 28, 2004
32
8
I did, but it goes flashing red after successful glitch. I did with nand x. I'll try with rawflash now.
 
L2000

L2000

VIP Member
Mar 8, 2011
271
33
Cape Town
I think he means write back the original stock nand remove the coolrunner,test to see if it boots with all stock.If it does then use stock nand image to get your ecc image flashed install your coolrunner and check from there making sure your image is corresponding to the dash version on console
 
A

AMIT

VIP Member
Nov 30, 2011
943
68
INDIA
L2000 said:
I think he means write back the original stock nand remove the coolrunner,test to see if it boots with all stock.If it does then use stock nand image to get your ecc image flashed install your coolrunner and check from there making sure your image is corresponding to the dash version on console
Click to expand...
Exactly !
 
P

Pepsi-Cola

Junior Member
Mar 8, 2012
17
0
Glad to see you got this working. i messed up on one of my consoles and went back to stock just to find out the console had been broken
 
You must log in or register to reply here.