TX Product(s) used: None
Console Type: Xenon
NAND size:16
Dashboard version:
CB version: 1903
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log:
updflash.bin log
Hello ,Dreds here again ,
Got so much help and advice from this site and its users , so i thought id post another problem im having .
Here goes :
So i had this original jtag which i did in about 2008 , the problem im having is that i cannot get it to boot xell or anything , it must have booted at some point because i had the cpu key written down , i think i dug it out last year to hack it not realising it already had xell on it and just carried on (big mistake ) , but i was new to soldering last year and i burnt the pad off of one of the nand points , so i sort of tried to restore the points and replace the trace .(as you can see in pic )
and i had to aslso find an alternative point for the orange wire .. The problem is when i write this dump back that i am sure is the original dump the console wont boot , green light flashes for a while the 3 red lights . When i use this dump and go through the process of creating xell , writing xell and writing nand the console will boot but the green light just flashes for ages on the front , doesn't red ring or anything.
ive tried extracting the kv , smc config and smc , and creating a fresh retail image but it will not have it lol
just looking for a bit on insight as iv'e been at it for a couple of days and hoping one of you members might have an insight
p.s i know the red wire in the pic is not in the right place but i have moved it
Thanks for reading and any help is greatly appreciated as i am now stuck lol
thanks again
dreds
Console Type: Xenon
NAND size:16
Dashboard version:
CB version: 1903
Screenshot of NAND details from J-Runner:
(attach an image to your post)
J-Runner log:
updflash.bin log
Hello ,Dreds here again ,
Got so much help and advice from this site and its users , so i thought id post another problem im having .
Here goes :
So i had this original jtag which i did in about 2008 , the problem im having is that i cannot get it to boot xell or anything , it must have booted at some point because i had the cpu key written down , i think i dug it out last year to hack it not realising it already had xell on it and just carried on (big mistake ) , but i was new to soldering last year and i burnt the pad off of one of the nand points , so i sort of tried to restore the points and replace the trace .(as you can see in pic )
and i had to aslso find an alternative point for the orange wire .. The problem is when i write this dump back that i am sure is the original dump the console wont boot , green light flashes for a while the 3 red lights . When i use this dump and go through the process of creating xell , writing xell and writing nand the console will boot but the green light just flashes for ages on the front , doesn't red ring or anything.
ive tried extracting the kv , smc config and smc , and creating a fresh retail image but it will not have it lol
just looking for a bit on insight as iv'e been at it for a couple of days and hoping one of you members might have an insight
p.s i know the red wire in the pic is not in the right place but i have moved it
Thanks for reading and any help is greatly appreciated as i am now stuck lol
thanks again
dreds
