Hello,
I have a problem what is getting me crazy.
I did a xbox before, so my drivers are good.
I have an 93450c. I followed the tut and make the cuts. I have maked the V cut and the strait one.
When i put the probe II on the points, the drive is detected. When i start the intro/ID and when it asked put the probe mra r/w, it starts reading for four lines and than says it can not read the drive.
I have tried it over 20 times.
What can be the problem.
Sorry for my bad english.
Fabian
I have a problem what is getting me crazy.
I did a xbox before, so my drivers are good.
I have an 93450c. I followed the tut and make the cuts. I have maked the V cut and the strait one.
When i put the probe II on the points, the drive is detected. When i start the intro/ID and when it asked put the probe mra r/w, it starts reading for four lines and than says it can not read the drive.
I have tried it over 20 times.
What can be the problem.
Sorry for my bad english.
Fabian