I have the Xecuter 2.6 CE installe on my Xbox, however when I went to flash it with the bios I got of #xbins, it seemed to flash ok, however when i turned the xbox on again with the chip enabled, the xbox seemed to quickly power on then of a few times this the CD tray light flashed red, when I turend the chip off the xbox boots normally, and it also boots to the chip screen fine if I switch to bank 2?
Problem
- Thread starter kommanderkrane
- Start date
You booted the wrong bios for your xbox... get the right one.
Hint... it's the other one. If you have one... it's the other one... get it?
Hint... it's the other one. If you have one... it's the other one... get it?
which box version do you have?
which bios are trying to flash?
the latest x2 bios has 2 versions
vOld - v1.0-1.5
v16plus - v1.6/1.6b
make sure you flash with the correct one
which bios are trying to flash?
the latest x2 bios has 2 versions
vOld - v1.0-1.5
v16plus - v1.6/1.6b
make sure you flash with the correct one
naw... you just boot your back-up and re-flash.
Memorey banks on your chips are like little HDD's... you can just keep re-writing to them.
They're acctually more like your RAM except not volitile.
IN any event just reboot, get to the flash bios screen, set your dip switches coeerctly and flash the bios.
Memorey banks on your chips are like little HDD's... you can just keep re-writing to them.
They're acctually more like your RAM except not volitile.
IN any event just reboot, get to the flash bios screen, set your dip switches coeerctly and flash the bios.